2-Port 1000Base-Fiber optucal Ports + 4-Port 10/100/1000Base-T eletrical ports ethernet Switch

Overview

10/100/1000M Ethernet Optical Fiber Switch is with four 10/100/1000M UTP ports and two 1000M SFP/SC/FC/ST Fiber ports. The end users can use different optical module according to his requirement, for example: 1000Base-T, 1000Base-SX, 1000Base-LX etc.

Support Auto-MDI/MDIX

Normally, Twisted Pair ports must be connected so that the Transmit pair on one end is connected to the Receive pair on the other end, and vice versa. If the cabling is done so that Transmit on one end is wired to Transmit on the other, and Receive is wired to Receive, the link will not come up.

Hubs and switches are deliberately wired opposite the way end stations are wired, so that when a hub or switch is connected to an end station, a “straight through” ethernet cable can be used and the pairs will match up properly. When two hub/switches are connected to each other, or two end stations are connected to each other, a “crossover” cable is used to make sure that the correct pairs are connected.

The standard wiring for end stations is known as “MDI” (Media Dependent Interface), and the standard wiring for hubs and switches is known as “MDIX” (Media Dependent Interface with Crossover).

On certain devices, it is possible for hardware to automatically correct errors in cable selection, making the distinction between a “straight through” cable and a “crossover” cable unimportant. This capability is known as Auto-MDI/MDIX.

On some products, including the CFETF100 Media Converter, Auto-MDI/MDIX is simply either enabled or disabled. When disabled, the port reverts to MDI mode.

On other products, like the CBFTF100 Switch, Auto-MDI/MDIX on Twisted Pair switch ports can be set to auto, MDI, or MDIX. For fiber switch ports, Auto-MDI/MDIX has a read-only value of notApplicable.

Features

1. 4*RJ45 ports and 2*optical sockets, convert Optical-Electric Ethernet signals between 10/100/1000M UTP ports and 1000M optical fiber ports;

2. Switch Ethernet signals between port and port;

3. Supports Auto MDI / MDI-X function;

4. Supporting the transmission of extra-long VLAN packets;

5. Flow control for full duplex and half duplex;

6. All optical module brands are supported; if SFP type, support hot-plug supported.

Parameter

Ordering information

Natywish was founded in 2006,  more than 10 years development and production experiences , our company has been concentrating on the fileds of Pon syestems and has been devoted to the R&D of relevant products solution .

Our main produce GPON/EPON OLT, ONU, advantage products also including media converter, POE switch, industrial switch. Production is base on the largest PON foundry factory in Shenzhen, which has 60000 square meters.

Natywish has become a leader and expert in security and fiber optical communication industry in China.