10B sprocket, 35 teeh sprocket, chain sprocket,gears

Chain sprocket applications: widely used in chemical, textile machinery , food processing , instrumentation , oil

and other industries , such as mechanical transmission .
Chain Model: contains non -standard sprockets ( customized according to customer drawings ), standard sprocket (

American standard and metric ) .
Sprocket commonly used materials : C45
Sprocket teeth should ensure that the material has sufficient strength and wear resistance , the surface of the

sprocket teeth are generally heat treated , so as to achieve a certain hardness .
Sprocket common processing methods : quenching, black surface treatment

British Standard Sprockets

American Standard Sprockets

* Calculating the PCD with this method can result in a small variation from the exact PCD.

The exact PCD can be calculated using the formula:

** Approximate figure only for calculating space requirements for sprockets

Chain sprocket Maintenance

1 , the tightness of the chain sprocket should be appropriate, too tight will increase power consumption , bearing

easy to wear ; too loose off the chain and sprocket easily beating . Tightness of the chain is: lift or pressure

from the middle of the chain , the two sprocket center distance of about 2 % -3 %.
2 , sprocket mounted on the shaft should be no wobble and skew . In both end surfaces of the same chain drive

assembly to be located in the same plane, the sprocket center distance 0.5 m or less, the deviation 1 mm ; center

distance when a chain of more than 0.5 m , the deviation can be 2 mm . But not the phenomenon of friction sprocket

side , if two offset too large chains and prone to accelerated wear off . When replacing the sprocket must be

careful to check and adjust the offset.

3 , sprocket wear serious , it should also replace the new chain sprockets and new , to ensure good engagement . Not

just a single new replacement sprocket or sprockets . Otherwise it will cause bad engagement , accelerate new

sprocket or new sprocket wear. Sprocket tooth wear to a certain extent should be promptly turned over to use ( refer

to the surface using an adjustable chain ) , to extend the use of time .

4, new or used chain sprocket elongation after long and difficult adjustment , removed the link to see the situation

, but it must be an even number. Back through the chain links should the locking plate is inserted on the outside,

the opening of the lock piece to be rotated toward the opposite direction.

5 , sprockets at work should be promptly filling oil . Lubricants must enter the roller and the inner sleeve with

the gap , to improve working conditions and reduce wear.

6 , the old part of the new chain sprocket can not be mixed with , or prone to shocks in the drive , and pull off

the sprocket.

7 , when the machine is long-term storage , remove the chain sprocket should be cleaned with kerosene or diesel oil

, then coated with oil or butter stored in a dry place.

ATTACHED THE SPROCKETS CATALOGUE

IF you need other chains or sprocket,please feel free to contact us by:

email:INFO@UIB-BEARING.COM

MSN:UNITE-BEARING@HOTMAIL.COM

SKYPE:UNITE-BEARING

Set up in 2004,our chain factory is the chain link manufacturer enterprise.The company specialized in production all kinds of

chains.The company owns a total area of 110,000 square meters and a perfect manufacturer and detection installation system,

a strong technique and advanced production.

The company is mainly operating carbon steel,stainless steel chains.

"Help to make solidiffy,expand and development" is our enterprise spirit.

Warmly welcome friends and walks to hold business talks and make progress.